×

LP1

LP2

LP3

LP4

LP2XL

Locate Dealer Build Your RapidTag Customization Talk to Engineer Contact Us

[su_button background="#ff6600" size="6" link="https://aspesite.com/get-pricing/"] GET A QUOTE [/su_button]
[su_button background="#ff6600" size="6" link= "https://aspesite.com/byrt/"] BUILD YOUR RAPID TAG [/su_button]

Specifications

  • 8x Stations
  • 3x Print Heads
  • 3x High Density Flash Cure Units
  • Max Image Area 6" x 6" inch (15 cm x 15 cm)
  • Standard Pallet Size 4" Wide x 8 " Long (10 cm x 20 cm)
  • Standard Frame Size 9" x 14" (22 cm x 35 cm)

Power Requirements

  • 220 Volt
  • Single Phase
  • 25 amps

Air Requirements

  • Clean dry air
  • 90-110 psi
  • 3.63 cfm

[su_button background="#ff6600" size="6" link="https://aspesite.com/get-pricing/"] GET A QUOTE [/su_button]
[su_button background="#ff6600" size="6" link= "https://aspesite.com/byrt/"] BUILD YOUR RAPID TAG [/su_button]

Specifications

  • Air Consumption - 90-110 psi / 2.48 cfm
  • Diameter - 117 cm (46")
  • Elec. Requirements - 220v single phase 20amp
  • Max Frame Size - 35 cm x 50.80 cm (14" x 20")
  • Max Image Size - 30 cm x 30 cm (12" x 12")
  • Shipping Weight - 458 lbs.
  • Standard Pallet Size - 25.40 cm (10")
  • Stations - 6
  • Colors - 2
  • Flash Cures - 3

[su_button background="#ff6600" size="6" link="https://aspesite.com/get-pricing/"] GET A QUOTE [/su_button]
[su_button background="#ff6600" size="6" link= "https://aspesite.com/byrt/"] BUILD YOUR RAPID TAG [/su_button]

FORGOT YOUR DETAILS?

SWIMMING CAPS

CAPS

PRINTING ON SWIMMING CAPS

A 200-325 mesh screen is recommended. Silkscreen inks are concentrated and should be diluted with a mineral spirit solvent in the range of 30% solvent to 70% ink by volume. Thinners can be supplied with the ink or purchased from a local supplier. After dilution, the ink should air dry in 3-5 minutes. The ink cures at 300f-400f in two to six minutes creating the permanent marking you are trying to achieve. Don’t worry about your part being able to take the heat either because most silicone parts can take 500 – 550f continuously. If your part melts then its not silicone and you are using the wrong ink!

RapidTag (Rapid Tag) screen printing videos

SPECIFICATIONS TABLE

Substrate Silicone, latex
Speed 1000-2000 pcs per hour
Finish Glossy finish
Pallet Adhesive Minimal
Mesh / Emulsion Multiple screen 110-200 / Liquid
Similiar Application(s) -
Special Instructions Ask ASPE for specifications on ink
TOP
Translate »